WeiderPro 30963.0 User Manual page 14

16. Orient a Press Arm Handle (17) with the 90° bend
at the top as shown in the inset drawing. Attach a
Press Arm Handle to the Right Press Arm (16)
with two M10 x 65mm Button Bolts (106), four
M10 Washers (80), four 11mm Spacers (99), and
two M10 Nylon Locknuts (77).
Repeat this step for the Left Press Arm (not
shown).
17. Attach the Left Press Arm (15) to the Right Press
Arm (16) with an M10 x 110mm Bolt (93), an
89.5mm Spacer (59) and an M10 Nylon Locknut
(77).
Finish attaching the Press Arms (15, 16) with two
M10 x 65mm Bolts (85), two M10 Washers (80),
and two M10 Nylon Locknuts (77). Do not tight-
en the Nylon Locknuts yet.
18. Attach the Left and Right Press Arms (15, 16) to
the Base (1) with an M10 x 110mm Bolt (93), an
89.5mm Spacer (59), and an M10 Nylon Locknut
(77). Do not over tighten the Nylon Locknut;
the Press Arms (15, 16) must be able to pivot
freely.
Tighten the M10 Nylon Locknuts (77) used in
step 17.
16
80
106
90° Bend
17
16
77
80
18
16
77
14
77
80
99
99
80
99
99
80
16
77
15
59
93
15
1
59
93
Grease
90°
Bend
17
85