WeiderPro 30963.0 User Manual page 10

4. Orient the Frame (9) so that the indicated hole is
on the side shown. Then, attach the Frame to the
Upright (2) with two M8 x 80mm Bolts (100), two
M8 Washers (103), and two M8 Nylon Locknuts
(78). Do not tighten the Nylon Locknuts yet.
Attach the Frame (9) to the Front Leg (10) with
two M8 x 65mm Bolts (101), two M8 Washers
(103), and two M8 Nylon Locknuts (78). Do not
tighten the Nylon Locknuts yet.
5. Attach the bottom of the Left Shroud (21) to the
Base (1) with two M4 x 12mm Self-tapping
Screws (102).
Repeat this step for the Right Shroud (not
shown).
6. Note: Some parts have been removed to show
this step clearly.
Slide the two Weight Bumpers (71) onto the
Weight Guides (18). Orient nine Weights (19) with
the pin holes on the bottom as shown. Slide the
Weights onto the Weight Guides.
Insert the Weight Tube (20) into the nine Weights
(19). Make sure that the pin on the Weight
Tube is oriented as shown.
Lubricate the indicated holes in a Weight (19) with
the included grease packet. Slide the Weight onto
the Weight Guides (18).
4
78
103
101
5
102
6
Pin
Pin
Hole
71
10
2
78
9
100
103
78
Hole
78
100
103
10
1
21
18
Grease
19
20
19