WeiderPro 30963.0 User Manual page 16

22. Wrap the Butterfly Cable (50) over a "V"-pulley
(47). Attach the "V"-pulley, a Long Cable Trap
(57), an M10 Washer (80), and two Guards (54)
to the Upright (2) with an M10 x 60mm Bolt (79)
and an M10 Nylon Locknut (77).
23. Grease an M8 x 22mm Shoulder Bolt (90). Attach
the Butterfly Cable (50) to the Right Butterfly
Bracket (29) with the Shoulder Bolt and an M8
Nylon Locknut (78). Make sure that the flat edge
of the Cable is against the Butterfly Arm.
24. Identify the Lat Cable (49). Route the Cable up
through the Top Frame (4) and over a 90mm
Pulley (48). Attach the Pulley inside the Top
Frame with an M10 x 80mm Bolt (84), two M10
Washers (80), two 19mm Spacers (67), and an
M10 Nylon Locknut (77).
22
54
79
47
80
54
23
Grease
29
Flat Edge
24
84
80
67
49
16
57
50
2
77
50
90
78
48
4
67
80
77