Live Video Connection Options; Configuring The Video Input Source; S-Video - High End Systems DL.3 User Manual

CHAPTER 15
Live Video Input and Control

Live Video Connection Options

The DL.3 fixture has video connectors for RGBHV, VGA and S-Video on its rear panel, as shown
in the following figure.
including hard drives
USB 1
USB 2
100-120 V;
50-60Hz; 7A
200-240 V;
50-60Hz; 3.5 A
S-Video Camera
Output to another
DL.3 fixture or device
CAUTION:
To avoid damaging the fixture and voiding the warranty, do not
physically connect to the RGBHV and VGA inputs at the same time.

Configuring the Video Input Source

S-Video

DL.3 fixtures support multiple SVideo formats including:
NTSC_M
NTSC_MJ
You will need to configure the DL.3 fixture to identify which video input source you have chosen.
The active input can be configured the following ways:
• Manually using the DL.3 menu system (see information about the Projector Input field on
the "Set_Projector Screen" on page 3-31.)
• Remotely through the CMA (see "DL.3 and DL.2 Media Server Configuration Options" on
page 16-208).
• Via the DMX console commands (see "Projector Control" on page 14-181).
NOTE: The integrated camera provides an NTSC_M video signal.
184
VGA input to
the projector
S-Video In to
the graphics engine
PAL_B PAL_H
PAL_D PAL_I
PAL_G PAL_M
PAL_N
running the CMA
SDI Output
RGBHV input option
to the projector
SECAM_B SECAM_K
SECAM_D SECAM_K1
SECAM_G SECAM_L
SECAM_H SECAM_L1
DL.3 Digital Light User Manual
SDI Input