Dish Network Hopper User Manual page 82

Chapter 10
Controlling Other Components
3
AUX
For
VCR, or 2 for an audio tuner or amplifier.
Then press the
4
Press the remote's
5
Press the
repeatedly until the device turns off.
6
Press the
7
Turn the device back on and try some other
buttons to make sure that they work also.
8
If necessary, repeat this procedure until
you've tried all the different codes and
chosen the one that works best with your
device.
Checking the Device Codes
Use these steps to find the device code you've set for each of the remote control modes
(TV, DVD/BD or VCR, and AUX)
1
Press and hold the mode button until
all the other mode buttons light up, and
then release the button. The device
mode button flashes.
74
mode only. Press 0 for TV, 1 for
STAR
(*) button.
POWER
button.
UP DOWN ARROW
or
POUND (#)
button.
.
Instructions
This step is for specifying the type of device that will
AUX
be programmed in mode. If you're not
AUX
programming in mode, please skip to step 4.
This puts your remote into code scanning mode.
UP DOWN ARROW
As you press the or
remote tries each code in its memory to see if it can
turn off your device. When the device turns off, you
have found a code that might work with your device.
Note: The mode button for the device will flash
rapidly eight times when you've scanned through all
the available codes for the specified device.
The device mode button flashes three times if you
have entered the code correctly, and saves the code
you found.
POWER
Sometimes works when other buttons
don't. If in Limited Mode (see step 6 on page 73),
VOLUME MUTE
also try or
You may need to repeat the scan to find the best
code for your particular device.
Note: This process could be lengthy, because of this
remote control's very large device-code database.
Additional Information
For example, hold the TV button until all of the
other mode buttons light. When you let go, the
TV mode button will flash.
, the
.