Dish Network Hopper User Manual page 81

Instructions
5
Enter one of the three-digit device codes
from the table using the
6
If you want to program Limited Mode, press
1. If not, skip to step 7.
7
POUND
Press the (#) button.
8
POWER
Press to turn off the device. If the
device does not turn off, go to step 10.
9
Turn the device back on and try some other
buttons to make sure they work. If the code
works for other buttons, you can stop here.
10
If the code doesn't work, repeat steps 3
through 9 with another device code from
the tables.
11
If you can't find a code that works, then try
Setting Up Using Device Codes Scan on
page 73.
Setting Up Using Device Codes Scan
If the code for your device is not listed in the tables in Remote Manager, or if you could not
find a code that worked for your device, use this procedure to scan through the remote
control's memory for the device code. In the instructions below, the column on the left
contains basic instructions and the column on the right provides additional information.
Instructions
1
Turn the device on.
2
Press and hold the mode button until all the
other mode buttons light up, and then
release the button. The device mode button
flashes.
The three-digit device code is for the brand name of
your device that you found in step 2.
NUMBER
buttons.
See Limited Mode for more information.
If you entered the code correctly, then the device
mode button flashes three times.
If the code works, then the device should turn off.
Sometimes
don't. If in Limited Mode, try
Try every code listed in the tables for your brand
until one works for your device.
Use the device's front panel buttons or its own
remote control.
For example, hold the
other mode buttons light up. When you let go, the TV
mode button will flash.
Remote Controls
Controlling Other Components
Additional Information
POWER
works when other buttons
VOLUME
or
Additional Information
TV
mode button until all of the
MUTE
.
73