Dish Network Hopper User Manual page 21

Remote Control Batteries
Each remote control comes with four AAA batteries. When you replace old
batteries, you should replace all of the batteries. Use batteries of the same
type together, for example, all alkaline or carbon zinc. Don't mix batteries of
different types/chemistries. Alkaline batteries last longer than carbon zinc.
1
Press down on the dimple at the top of the battery cover on the back of the
remote control and slide off the cover.
2
Take out all four of the old batteries.
3
Put in the new batteries. Make sure you match the plus ("+") ends with the
plus markings on the battery case.
4
Slide the battery cover back into place on the back of the remote.
Low Battery Warning
When you see a low-battery warning message on your screen below the Program Banner,
the batteries in your remote control are weak and need to be replaced.
Attach the Remote Control Antenna
Attach the remote-control antenna to the R
back panel so you can use your UHF-2G remote. Without the remote-control antenna
attached, you cannot use this remote to control the receiver. See Adjusting the Remote
Control Antenna on page 69 for more detailed information about improving the
performance of your UHF-2G remote control. (Image may vary.)
Satellite Receiver
A connection on the Hopper
EMOTE NTENNA
Remote Control
13