Dish Network Hopper User Manual page 78

Chapter 10
Pairing Your Remote Control
Installing a UHF Attenuator
Unwanted UHF signals may interfere with signals from the remote control to the receiver.
To prevent such interference, you can install a 10 dB attenuator (available from many
electronics parts stores). Adding this attenuator will help keep out stray UHF signals, but it
will also cut down how far away your remote control can operate the receiver.
1
Remove the remote control antenna from the
R
EMOTE
panel.
2
Attach a 10 dB attenuator directly to the R
A
NTENNA
3
Attach the remote control antenna to the newly
installed attenuator.
70
A input on the receiver's back
NTENNA
input.
EMOTE