Configuring The Protocol-Based Vlan - H3C S9500 Series Operation Manual

Operation Manual – VLAN
H3C S9500 Series Routing Switches

1.5.2 Configuring the Protocol-Based VLAN

Note:
Protocol VLAN is only applicable to a hybrid port belonging to the VLAN to which a
protocol is to be issued.
Follow these steps to configure a protocol-based VLAN:
Enter system view
Enter VLAN view
Configure the protocol
based VLAN and
specify the protocol
template
Return to system view
Enter
Ethernet
interface
view or port
group view
Configure the port link
type as hybrid
Allow specified VLANs
to pass through the
current hybrid port
Configure the
association between the
hybrid port and the
protocol-based VLAN
To do...
system-view
vlan vlan-id
protocol-vlan [ protocol-index ]
{ at | ipv4 | ipv6 | ipx
{ ethernetii | llc | raw | snap } |
mode { ethernetii etype
etype-id | llc { dsap dsap-id
[ ssap ssap-id ] | ssap ssap-id }
| snap etype etype-id } }
quit
Enter
Ethernet interface interface-type
interface interface-number
view
Enter
port-group { manual
port
port-group-name | aggregation
group
agg-id }
view
port link-type hybrid
port hybrid vlan vlan-id-list
{ tagged | untagged }
port hybrid protocol-vlan
vlan vlan-id { protocol-index [ to
protocol-end ] | all }
Use the command...
1-11
Chapter 1 VLAN Configuration
Remarks
—
Required
For a nonexistent
VLAN, this command
will create a VLAN and
enter its view.
Required
—
Use either command.
Under Ethernet
interface view, the
subsequent
configurations only
apply to the current
port; under port group
view, the subsequent
configurations apply to
all ports in the port
group.
Required
Required
Required