Configuring Rpr Pos Interface - H3C S9500 Series Operation Manual

Operation Manual – RPR
H3C S9500 Series Routing Switches
Set the TC slow timer
Set the TP fast timer
Set the TP slow timer
Set the WTR timer

1.9 Configuring RPR POS Interface

Follow these steps to configure an RPR POS interface:
To do...
Enter system view
Enter RPR POS
interface view
Configure SD
2
SF thresholds
Note:
1. SD = Signal degrade
2. SF = Signal failure
Note:
For description about the threshold command, refer to POS Interface Configuration
in the Access Volume.
For physical parameters configuration on RPR POS interfaces, refer to POS
Interface Configuration in the Access Volume.
To do...
rpr timer tc-slow value
rpr timer tp-fast value
rpr timer tp-slow value
rpr timer wtr value
Use the command...
system-view
interface rprpos
interface-number
1
and threshold { sd | sf }
value
Use the command...
—
Required
Optional
The default SD threshold is 5 and
the default SF threshold is 3. The
value of SF must be smaller than
SD, and their difference must not be
larger than 2.
1-15
Chapter 1 RPR Configuration
Remarks
Optional
100 milliseconds by
default
Optional
10 milliseconds by default
Optional
100 milliseconds by
default
Optional
10 seconds by default
Remarks