Configuring An Isolation Group; Assigning Ports To An Isolation Group - H3C S9500 Series Operation Manual

Operation Manual – Port Isolation
H3C S9500 Series Routing Switches
Figure 1-2 Layer-2 communication in the same VLAN when port isolation is used
Note:
The arrows in the above figure indicate the transmission direction of layer 2 traffic.
As shown in the above figure, in a VLAN, ports outside isolation groups can access
isolated ports but not vice versa.

1.2 Configuring an Isolation Group

1.2.1 Assigning Ports to an Isolation Group

Follow these steps to assign a port or a group of ports to an isolation group:
Enter system view
Create an isolation
group
To do...
system-view
port-isolate group
group-number
Chapter 1 Port Isolation Configuration
Use the command...
1-3
Remarks
—
Required