Entering Aggregation Port Group View - H3C S9500 Series Operation Manual

Operation Manual – Link Aggregation
H3C S9500 Series Routing Switches
Enter Ethernet interface
view
Assign the Ethernet port
to the service loop group
Note:
You can define only one service loop group for each service loop group type.
Only one service type can be specified for a service loop group.
There can only be up to eight Ethernet ports valid for each service loop group type.
An Ethernet port can be added to a service loop group only when STP is not
enabled on it.
You can change the type of an existing service loop group. The operation fails if it is
currently referenced by a module or the service loop group contains ports whose
attributes conflict with the intended service type.
You can use the undo link-aggregation group command to remove a service loop
group. The operation fails if it is currently referenced by a module.
For a service loop group containing only one port, you can remove the port from the
service loop group only by removing the service loop group.

2.1.5 Entering Aggregation Port Group View

In aggregation port group view, you can make configuration for all the member ports in
a link aggregation group at one time.
Follow these steps to enter aggregation port group view:
Enter system view
Enter aggregation port group view
Caution:
In aggregation port group view, you can configure aggregation related settings such as
STP, VLAN, QoS, GVRP, QinQ, BPDU tunnel, MAC address learning, but cannot add
or remove member ports.
To do...
interface interface-type
interface-number
port link-aggregation group
agg-id
To do...
Chapter 2 Link Aggregation Configuration
Use the command...
Use the command...
system-view
port-group aggregation agg-id
2-4
Remarks
––
Required
Remarks
––
––