H3C S9500 Series Operation Manual page 20

Operation Manual – Ethernet Interface
H3C S9500 Series Routing Switches
Caution:
After you configure the source MAC address for an interface, packets forwarded on
Layer 3 through the interface use the MAC address of the corresponding VLAN
interface as their source MAC addresses, with the least octet being replaced with value
specified by the source-mac-tail command.
Note:
Currently, this command is not supported on the following boards: LSB1GV48DA,
LSB1GV48DB, LSB2GV48DA, LSB1GP48DB, LSB1XP4B, LSB1XP4CA, and
LSB1XP4DB.
1.2 Displaying and Maintaining Ethernet Interfaces
Display the information of
Ethernet interfaces
Display the brief
information of Ethernet
interfaces
Display the ports that are
of a specified type
Display the information
about a manual port group
or all the port groups
Display the statistics on
the packets passing
through interfaces of
specific type
Display the rate statistics
on the packets passing
through the interfaces
within the last sample time
interval
Display the alarm
information of pluggable
optical modules
To do...
display interface
[ interface-type
[ interface-number ] ]
display brief interface
[ interface-type
[ interface-number ] ] [ |
{ begin | include |
exclude} text ]
display port { hybrid |
trunk }
display port-group
manual [ all | name
port-group-name ]
display counters
{ inbound | outbound }
interface [ interface-type ]
display counters rate
{ inbound | outbound }
interface [ interface-type ]
display transceiver
alarm interface
[ interface-type
interface-number ]
Chapter 1 Ethernet Interface Configuration
Use the command...
1-11
Remarks
Available in any view
Available in any view
Available in any view
Available in any view
Available in any view
Available in any view
Available in any view