Configuring Protection Mode; Configuring Protection Reversion Mode - H3C S9500 Series Operation Manual

Operation Manual – RPR
H3C S9500 Series Routing Switches
Configuring RPR VLAN Tunnel
Testing Connectivity Between Stations

1.3 Configuring Protection Mode

Follow these steps to configure the protection mode on the RPR station:
Enter system view
Enter RPR logical
interface view
Configure the
protection mode
Caution:
All the stations on an RPR ring must adopt the same protection mode for the ring to
operate normally.

1.4 Configuring Protection Reversion Mode

Two protection reversion modes are available:
Revertive mode, where a station resumes the idle protection state once the WTR
timer expires.
Non-revertive mode, where the station remains in automatic protection state upon
expiration of the WTR timer and does not resume the idle state until a higher
protection request is present on the ring.
Follow these steps to configure the protection reversion mode on the RPR station:
Enter system view
Enter RPR logical
interface view
Task
To do...
system-view
interface interface-type
interface-number
rpr protect-mode { steer |
wrap }
To do...
system-view
interface interface-type
interface-number
Use the command...
Use the command...
1-10
Chapter 1 RPR Configuration
Remarks
Optional
Optional
Remarks
—
—
Optional
Steering mode applies by
default.
Remarks
—
—