Configuring Port Type; Configuring Station Name; Configuring Protection Requests - H3C S9500 Series Operation Manual

Operation Manual – RPR
H3C S9500 Series Routing Switches

1.10 Configuring Port Type

Follow these steps to set physical RPR port type on an RPR logical port:
Enter system view
Enter RPR logical
interface view
Set RPR physical port
type
Caution:
After you change the RPR port type, the interface card will reboot to have the
change take effect. The previous settings on the interface card will be lost as a
result.
The rpr port-type command can only take effect on 10 Gbps POS and 10GE
physical ports. It cannot take effect on 2.5 Gbps POS ports.

1.11 Configuring Station Name

Follow these steps to assign a name to the RPR station:
To do...
Enter system view
Enter RPR logical
interface view
Configure a station
name

1.12 Configuring Protection Requests

A station can automatically send protection requests onto an RPR ringlet to trigger
protection. Besides that, you may send FS or MS protection requests manually to
trigger protection or send idle protection requests to clear the manually sent protection
requests present on a ringlet.
To do...
system-view
interface interface-type
interface-number
rpr port-type { 10gpos |
10ge }
Use the command...
system-view
interface interface-type
interface-number
rpr station-name
station-name
Use the command...
1-16
Chapter 1 RPR Configuration
Remarks
—
—
Optional
The RPR port type
detected at initialization
applies by default.
Remarks
—
—
Required
No station name is
configured by default.