H3C S9500 Series Operation Manual page 39

Operation Manual – GVRP
H3C S9500 Series Routing Switches
# Create VLAN 2 (a static VLAN).
[SysnameA] vlan 2
[SysnameA-vlan2] return
2) Configure Switch B
# Enable GVRP globally.
<SysnameB> system-view
[SysnameB] gvrp
# Configure port Ethernet 1/1/2 as a trunk port, allowing all VLANs to pass.
[SysnameB] interface ethernet 1/1/2
[SysnameB-Ethernet1/1/2] port link-type trunk
[SysnameB-Ethernet1/1/2] port trunk permit vlan all
# Enable GVRP on Ethernet 1/1/2.
[SysnameB-Ethernet1/1/2] gvrp
[SysnameB-Ethernet1/1/2] quit
# Create VLAN 3 (a static VLAN).
[SysnameB] vlan 3
[SysnameB-vlan3] return
3) Verify the configuration
# Display dynamic VLAN information on Switch A.
<SysnameA> display vlan dynamic
No dynamic VLAN exists!
# Display dynamic VLAN information on Switch B.
<SysnameB> display vlan dynamic
No dynamic VLAN exists!
1-11
Chapter 1 GVRP Configuration