Key Operator Code - Lanier Copier System Edition Operating Instructions Manual

You can switch the display by pressing [U U U U
Prev.] or [T T T T Next].
The selected item is highlighted.
When you specify all the settings, press [OK].
If [OK] is not pressed, the settings you made
might be canceled.
Press [Cancel] to cancel specified settings.
The previous display is shown.

- Key Operator Code

- - -
When Key Operator Code is programmed and
turned on, users have to enter a programmed Key
Operator Code (maximum 8 digits) to operate the
User Tools and Key Operator Tools. This pre-
vents unauthorized people from changing regis-
trations.
Note
You can turn the Key Operator Code on or off
in the "System Settings".
When you set the Key Operator Code active,
enter a code (maximum 8 digits) with the
number keys and select [Partial] or [All Initial
Settings] to limit access.
• When [Partial] is selected:
Operating InstructionsFacsimile Reference (option) <Advanced Features>
Only the Key Operator Tools are protected
with a Key Operator Code.
• When [All Initial Settings] is selected:
The Key Operator Tools and User Tools
are protected with a Key Operator Code.
Press the { { { { User Tools/Counter} } } } key.
A
If you have selected [All Initial Settings],
go to step C.
B
Select [Key Operator Code].
C
Press [Facsimile Features].
D
Enter a maximum 8 digit Key Operator
Code with the number keys.
E
Press [OK].
171