Canceling A Memory Transmission; Before The Start Key Is Pressed; While The Original Is Being Scanned; During Transmission - Lanier 3730 Operating Instructions Manual

Canceling a Memory Transmission

Before the Start Key is Pressed

A
Press the {Energy Saver / Clear
Modes} key.
Note
❒ When you have already set the
original, you can also cancel the
transmission by removing the
original from the machine.
While the Original is Being
Scanned
A
Press the {Clear/Stop} key.
The machine will stop storing the
original and the data will not be
sent.
Canceling a Memory Transmission

During Transmission

Use this procedure to cancel a trans-
mission after the original has been
scanned.
Note
❒ If transmission finishes while you
are carrying out this procedure, it
will not be canceled.
❒ If you cancel a message while it is
being sent, transmission is halted
as soon as you finish this proce-
dure. However, some pages of
your message may have already
been sent and will be received at
the other end.
A
Press the {Job Information} key,
and confirm that " 1. Cancel TX /
RX " is displayed.
The Information menu is shown.
B
Press the {OK } key.
2
29