Recording To A Cassette Tape - Sharp GX-CD1300MP MK2 Operation Manual

Recording to a cassette tape

GX-CD1300MP
MK2
ENGLISH
Before recording:
●
When recording important selections, make a preliminary test to
ensure that the desired material is properly recorded.
●
SHARP is not liable for damage or loss of your recording arising
from malfunction of this unit.
●
The volume and sound controls can be adjusted with no effect
on the recorded signal (Variable Sound Monitor).
●
For recording, use only normal tapes. Do not use metal or
CrO tapes.
2
Erase-prevention tab of cassette tapes:
●
When recording on a cassette tape, make sure that the erase-
prevention tabs are not removed. Cassettes have removable
tabs that prevent accidental recording or erasing.
●
To protect the recorded sound, remove the tab after recording.
Cover the tab hole with adhesive tape to record on the tape
without the tab.
Tab for side B
E-29
Side A
Tab for side A
BUILT IN MIC
BEAT CANCEL
C
A B
RECORD
PLAY
■
Recording from the CD/MP3
1
Set the FUNCTION switch to CD.
Load the disc to be recorded.
2
During CD stop mode, load a cassette into the TAPE 1
cassette compartment.
3
Set the DUBBING SPEED switch to NORMAL.
4
Press the RECORD button.
5
Press the / button on the CD player.
To stop recording:
Press the STOP/EJECT button.
The tape will stop.
Note:
If the or / button on the CD player is pressed whilst recording,
or if the CD comes to its end, the tape deck will not stop.
To record a specific track:
Press the ( ) or ( ) buttons or press the Direct Search
buttons on the remote control to select the track that you want to
record. Then start recording.
To perform programmed recording:
1 Programme the desired tracks. (See pages 24 - 25) Then start
playback.
2 Press the RECORD button to start recording.
/
.
.
TUNING
DUBBING SPEED
FUNCTION
TAPE1
PAUSE