Sharp GX-CD1300MP MK2 Operation Manual page 31

■
Recording from the radio
1
Tune in to the desired station. (See page 26)
2
Load a cassette into the TAPE 1 cassette compartment.
3
Press the PAUSE button of TAPE 1.
4
Press the RECORD button of TAPE 1, which also engages
the PLAY button.
5
Press the PAUSE button of TAPE 1 again to begin
recording.
Beat cancel switch:
If a whilstling noise occurs when recording from an MW, SW1 or
SW2 station, set the BEAT CANCEL switch to A, B or C, whichever
gives the best reception.
■
Recording from the built-in microphone
1
Set the FUNCTION switch to TAPE.
2
Set the DUBBING SPEED switch to MIC.
3
Load a cassette into the TAPE 1 cassette compartment.
4
Press the PAUSE button of TAPE 1.
5
Press the RECORD button of TAPE 1, which also engages
the PLAY button.
6
Press the PAUSE button again to begin recording.
Notes:
●
Do not connect anything to the MIX MIC socket.
●
Monitoring of the recording is not possible.
●
Recording from the built-in microphone is not in stereo.
■
Dubbing from tape to tape
1
Set the FUNCTION switch to TAPE.
2
Load a pre-recorded cassette into the TAPE 2 cassette
compartment. Insert a blank tape into the TAPE 1 cassette
compartment.
3
Set the DUBBING SPEED switch to NORMAL for normal
speed dubbing, HIGH for high-speed dubbing.
4
Press the PAUSE button of TAPE 1.
5
Press the RECORD button of TAPE 1, which also engages
the PLAY button.
6
Choose either side A(1) or side B(2) of TAPE 2 with the
DIRECTION switch.
7
Press the PLAY button of TAPE 2.
●
The PAUSE button of TAPE 1 will be released automatically
and dubbing from TAPE 2 to TAPE 1 will begin
(Synchronous dubbing start).
Notes:
●
Do not change the setting of the DUBBING SPEED switch during
dubbing.
●
Do not connect anything to the MIX MIC socket.
■
Erasing recorded tapes
1
Load the tape to be erased into the TAPE 1 cassette
compartment.
2
Set the FUNCTION switch to TAPE.
3
Set the DUBBING SPEED switch to HIGH or NORMAL.
●
Check to ensure that TAPE 2 is out of operation.
4
Press the RECORD button of TAPE 1 to begin erasing.
Note:
Do not connect anything to the MIX MIC socket.
GX-CD1300MP
MK2
ENGLISH
E-30