Sharp GX-CD1300MP MK2 Operation Manual page 9

■
Speaker connection
Connect each speaker wire to the SPEAKER terminals as shown.
Use speakers with an impedance of 6 ohms or more, as lower
impedance speakers can damage the unit.
1 2
Right speaker
SPEAKER (6 Ω)
+
RIGHT
Red
Black
Caution:
●
Connect the black wire to the minus (–) terminal, and the red wire
to the plus (+) terminal.
●
Do not mix the right channel and left channel wiring when
connecting the speakers to the unit.
●
Do not let the bare speaker wires touch each other as this may
damage the amplifier and/or speakers.
●
Do not stand or sit on the speakers. If the speakers fall or collapse,
you may be injured.
Note:
The speaker grille is not removable.
3
Left speaker
_ _
+
LEFT
Red
To AC INPUT
AC 110V AC 220V
- 127V - 240V
VOLTAGE
SELECTOR
AC 110V AC 220V
110 - 127/220 - 240 V
- 127V - 240V
VOLTAGE
50/60 Hz
SELECTOR
■
AC power connection
Check the setting of the AC voltage selector located on the rear
panel before plugging the unit into an AC socket. If necessary, adjust
the selector to correspond to the AC power voltage used in your
area.
Selector adjustment:
Slide the selector with a screwdriver to the appropriate voltage
number (AC 110 - 127 V or AC 220 - 240 V).
GX-CD1300MP
MK2
ENGLISH
1
2
To the wall socket
E-8