Sharp GX-CD1300MP MK2 Operation Manual page 24

CD/MP3 playback (continued)
GX-CD1300MP
MK2
ENGLISH
To interrupt playback:
Press the button on the remote control during playback.
Press the / ( ) again to resume playback from the same point.
To stop playback:
Press the button.
■
Cue and review
1
Load a disc and begin playback.
2
Hold down the
down the button for audible fast reverse.
●
Normal playback will resume when the
(Remote Control Operation)
●
Press button for audible fast forward, and press
button for audible fast reverse.
●
Press or
speed: 2x, 4x, 8x
●
Normal playback will resume when the
Notes:
●
When the end of the track is reached whilst cueing, the next track
will be played continuously.
●
When the end of the last track of disc is reached whilst cueing,
CD operation will be stopped.
●
If the beginning of the disc is reached whilst reviewing, the mode
will automatically switch to normal playback at that point.
E-23
PROGRAM/
PBC PAL/NTSC CLEAR OSD
1 2 3
DIGEST
4 5 6
DIRECT
AUDIO
7 8 9
MODE
PAUSE
VCD/CD
0 +10
MUTE RESUME
VCD/CD PAUSE
STOP REPEAT
STOP
VCD/CD
button for audible fast forward, and hold
or
again to select fast forward or fast reverse
button is pressed.
■
Repeat play
All tracks or a programmed sequence can be continuously repeated.
To repeat all tracks:
Press the /
●
" " will blinking.
●
TV screen : REP: [REP ALL]
To repeat a programmed sequence:
1 Programme a sequence of up to 32 tracks . (refer pages 24 -
25).
2 Press the
●
" " will blinking.
Note:
If the track number higher than 100 up to 330 (MP3 encoded disc),
only the last 2 digit of the track number will appear in the display
following by colour indicator.
The colour indicator will appears; green (100 up to 199), red (200
up to 299), and orange (300 up to 330).
PROGRAM/
PBC PAL/NTSC CLEAR OSD
1 2 3
DIGEST
4 5 6
DIRECT
is released. AUDIO
7 8 9
MODE
VCD/CD
0 +10
MUTE RESUME
VCD/CD PAUSE
STOP REPEAT
To cancel repeat play:
Press the /
●
TV screen : REP : [OFF].
( ) button once.
/ ( ) button once.
Play Indicator
Indicator: green,
red, orange.
REPEAT
( ) button until the " " indicator stop blinking.
Track
number
/