Remote Control - Sharp GX-CD1300MP MK2 Operation Manual

Remote control

■ Battery installation
1 Open the battery cover.
2 Insert the supplied batteries according to the direction
indicated in the battery compartment (back of the battery
cover).
When inserting or removing the batteries, push them towards the
battery terminals.
3 Close the cover.
Precautions for battery use:
●
Replace all old batteries with new ones at the same time.
●
Do not mix old and new batteries.
●
Remove the batteries if the unit will not be used for long periods
of time. This will prevent potential damage due to battery leakage.
Caution:
●
Do not use rechargeable batteries (nickel-cadmium battery, etc.).
●
Installing the batteries incorrectly may cause the unit to
malfunction.
●
Batteries (battery pack or batteries installed) shall not be exposed
to excessive heat such as sunshine, fire or the like.
Battery removal:
Open the battery cover and pull up the battery to take out.
Notes concerning use:
●
Replace the batteries if the operating distance is reduced or if the
operation becomes erratic. Purchase 2 "AA" size batteries
(UM/SUM-3, R6, HP-7 or similar).
●
Periodically clean the transmitter on the remote control and the
sensor on the unit with a soft cloth.
●
Exposing the sensor on the unit to strong light may interfere with
operation. Change the lighting or the direction of the unit.
●
Keep the remote control away from moisture, heat, shock, and
vibrations.
0.2 m - 6 m
(8" - 20')
PBC
1
4
7
0
.
.
PROGRAM/
PAL/NTSC CLEAR OSD
2 3
DIGEST
5 6
DIRECT
AUDIO
8 9
MODE
VCD/CD
+10
MUTE RESUME
VCD/CD PAUSE
STOP REPEAT
GX-CD1300MP
MK2
ENGLISH
E-10