Precautions - Sharp GX-CD1300MP MK2 Operation Manual

Precautions

GX-CD1300MP
MK2
ENGLISH
■
General
●
Please ensure that the equipment
is positioned in a well ventilated
area and ensure that there is at
least 10 cm (4") of free space along
the sides, top and back of the
equipment.
●
Use the unit on a firm, level surface free from vibration.
●
Keep the unit away from direct sunlight, strong magnetic fields,
excessive dust, humidity and electronic/electrical equipment
(home computers, facsimiles, etc.) which generate electrical
noise.
●
Do not place anything on top of the unit.
●
Do not expose the unit to moisture, to temperatures higher than
60°C (140°F) or to extremely low temperatures.
●
If your system does not work properly, disconnect the AC power
lead from the wall socket. Plug the AC power lead back in, and
then turn on your system.
●
In case of an electrical storm, unplug the unit for safety.
●
Hold the AC power plug by the head when removing it from the
wall socket, as pulling the lead can damage internal wires.
●
The AC power lead/AC power input socket is used as a
disconnect device and shall always remain readily operable.
●
Do not remove the outer cover, as this may result in electric
shock. Refer internal service to your local SHARP service
facility.
●
The ventilation should not be impeded by covering the ventilation
openings with items, such as newspapers, tablecloths, curtains,
etc.
●
No naked flame sources, such as lighted candles, should be
placed on the apparatus.
●
Attention should be drawn to the environmental aspects of battery
disposal.
●
This unit should only be used within the range of 5°C - 35°C
(41°F - 95°F).
Warning:
The voltage used must be the same as that specified on this unit.
Using this product with a higher voltage other than that which is
specified is dangerous and may result in a fire or other type of
accident causing damage. SHARP will not be held responsible for
any damage resulting from use of this unit with a voltage other than
E-3
that which is specified.
■
The sound level at a given volume setting depends on speaker
efficiency, location, and various other factors. It is advisable to avoid
10 cm (4")
exposure to high volume levels. Do not turn the volume on to full at
switch on and listen to music at moderate levels. Excessive sound
pressure from earphones and headphones can cause hearing loss.
10 cm
(4")
■
Sudden temperature changes, storage or operation in an extremely
humid environment may cause condensation inside the cabinet (CD
pickup, tape heads, etc.) or on the transmitter on the remote control.
Condensation can cause the unit to malfunction. If this happens,
leave the power on with no disc (or cassette) in the unit until normal
playback is possible (about 1 hour). Wipe off any condensation on
the transmitter with a soft cloth before operating the unit.
■
Compact discs are fairly resistant to damage, however mistracking
can occur due to an accumulation of dirt on the disc surface. Follow
the guidelines below for maximum enjoyment from your CD collection
and player.
●
●
●
Volume control
Condensation
Care of compact discs
Do not write on either side of the disc, particularly the non-label side
from which signals are read. Do not mark this surface.
Keep your discs away from direct sunlight, heat, and excessive
moisture.
Always hold the CDs by the edges. Fingerprints, dirt, or water on the
CDs can cause noise or mistracking. If a CD is dirty or does not play
properly, clean it with a soft, dry cloth, wiping straight out from the
centre, along the radius.
NO
YES Correct