Recording On A Cassette Tape - Sharp XL-MP35H Operation Manual

Recording on a cassette tape

XL-MP35H
ENGLISH
Before recording:
" When recording important selections, make a preliminary test to
ensure that the desired material is properly recorded.
" SHARP is not liable for damage or loss of your recording arising
from malfunction of this unit.
" The volume and sound controls can be adjusted with no effect on
the recorded signal (Variable Sound Monitor).
" For recording, use only normal tapes. Do not use metal or
CrO tapes.
" Do not use C-120 tapes or poor-quality tapes, as they may cause
malfunctions.
E-19
! Recording from a CD or MP3 disc
1
Press the ON/STAND-BY button to turn the power on.
2
Press the FUNCTION button until "CD" appears on the dis-
play.
When operating with the remote control, press the CD button.
3
Load the desired disc.
4
Load a cassette into the cassette compartment with the
side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
5
Press the button.
Recording will be paused.
6
Press the ( ) button to start re-
cording.
" Playback of the disc will start in a few seconds after the tape
starts.
" When the playback of the disc is finished or the end of the
tape is reached, the disc and the cassette will stop automat-
ically.
To perform programmed recording:
1 Programme tracks (see page 14).
2 Press the button.
3 Press the ( ) button.
To stop recording:
Press the button.
The disc and tape will stop.
To interrupt recording:
Press the button.
" Recording is paused, but disc playback will continue.
To resume recording, press the ( ) button.
03/8/20 XL-MP35H(H)E2.fm TINSZ0226SJZZ