Table of Contents
Advertisement
2-3. LOCATION
2-4. REMOVE CONTROL END
PANEL
203
Place the unit on a table, preferably with a cut-out opening below
the cabinet to allow easy service connections and serviceability.
When setting up the Henny Penny Display Counter Warmer,
be sure to level the table.
The unit has built-in draining capabilities, but this becomes
ineffective when set on an unlevel table.
After the Henny Penny Display Counter Warmer has been
leveled on the table, run a bead of silicone rubber (or equivalent
sealant) around the perimeter of the unit, sealing it to the table
top. You are now ready to make the electrical and drain
connections to the unit.
1. Remove the seven screws fastening the end panel to the
cabinet.
2. Slide bottom of end panel out first allowing top to drop
below shelf edge.
Step 2
Model CW-216/CW-114
2-3
Advertisement
Table of Contents
