Subscribe to Our Youtube Channel
Related Manuals for Henny Penny MP-941
Summary of Contents for Henny Penny MP-941
- Page 1 Henny Penny Model MP-941/942/943/944 Henny Penny Multipurpose Holding Cabinet Model MP-941 Model MP-942 Model MP-943 Model MP-944 OPERATOR’S MANUAL...
- Page 2 During this time, any frypot that fails due to manufacturing or workmanship issues will be replaced at no charge for parts, labor, or freight. Henny Penny will either install a new frypot at no cost or provide a new or reconditioned replacement fryer at no cost.
-
Page 3: Table Of Contents
3-1. Introduction ...3-1 3-2. Operating Controls and Components ...3-1 3-3. Start-Up ...3-2 3-4. Operating With Product...3-3 3-5. Cleaning...3-3 3-6. Operation and Programming...3-4 3-7. Error Codes ...3-6 GLOSSARY ...G-1 Distributor Lists – Domestic and International TABLE OF CONTENTS Model MP-941/942/943/944 Page... -
Page 4: Section 1. Introduction
Should you require outside assistance, just call your local Henny Penny distributor in your area, call Henny Penny Corp. at 1-800-417-8405 toll free or 1-937-456-8405, or visit Henny Penny online at... -
Page 5: Safety
1-5. SAFETY Model MP-941/942/943/944 The only way to ensure safe operation of the Henny Penny Multipurpose Holding Cabinet is to fully understand the proper installation, operation and maintenance procedures. The instructions in this manual have been prepared to aid you in learning the proper procedures. -
Page 6: Section 2. Installation
Do not puncture the skin of unit with drills or screws as component damage or electrical shock could result. The Henny Penny Multipurpose Holding Cabinet has been tested, inspected, and expertly packed to ensure arrival at its destination in the best possible condition. The cabinet rests on cardboard pads that sit on a wooden skid. -
Page 7: Data Table
(silicone or equivalent sealant must be a NSF listed material) around the perimeter of the unit sealing it to the surface. You are now ready to make the electrical connections to the unit. Model MP-941/942/943/944... -
Page 8: Cabinet Dimensions
Model MP-941/942/943/944 2-4. CABINET DIMENSIONS MP-941... - Page 9 Model MP-941/942/943/944 2-4. CABINET DIMENSIONS (Continued)
-
Page 10: Section 3. Operation
Special Program Mode A rocker switch that controls the power to the unit Used to view the drawer temperature, and to set the setpoint temperature for the drawer Used in the Program Mode Model MP-941/942/943/944 Function... -
Page 11: Start-Up
POWER switch to the ON position and adjust each control to the appropriate temperature. The power light should illuminate indicating that the unit is operating. The operating temperature of this unit should be achieved in approximately 30 minutes. Model MP-941/942/943/944... -
Page 12: Operating With Product
To avoid burns, allow the unit to cool before cleaning by opening all the drawers fully for approximately 20 minutes. 3. Remove the drawers by pulling straight out and tilting up. Step 3 4. Clean drawers with a cloth and soapy water. Model MP-941/942/943/944... -
Page 13: Operation And Programming
DOWN buttons to set the desired time. When the SET button is released the time will be saved. Temperature Setpoint Programming 1. Press and hold the appropriate drawer button for 6 seconds. The actual temperature will be shown first followed by the flashing setpoint temperature. Model MP-941/942/943/944... - Page 14 “ON” shows on the display during normal operation. Press and release the UP and DOWN buttons to toggle from “y” to “n” or vice versa. 10. Press and hold the set button to exit Special Program Mode at any time. Model MP-941/942/943/944...
-
Page 15: Error Codes
Setting Control to the Correct Number of Drawers The different models, MP-941, 942, 943, and 944, all use the same control board. The boards are programmed at the factory for the correct unit. But, should the unit show “E06”... -
Page 16: Glossary
G L O S S A R Y HENNY PENNY HOLDING CABINETS a round device located inside the cabinet that measures the inside air temperature and sends that information to the control panel a metal assembly located in the water pan in the bottom of the unit that... - Page 17 NOT be used to clean a holding cabinet the area in the cabinet that holds water for creating humidity inside the cabinet Model MP-941/942/943/944...
- Page 18 Henny Penny Corporation P.O.Box 60 Eaton,OH 45320 1-937-456-8400 1-937-456-8402 Fax Toll free in USA 1-800-417-8417 1-800-417-8434 Fax *FM05-017-E* www.hennypenny.com Henny Penny Corp., Eaton, Ohio 45320, Revised 02-21-08...
Need help?
Do you have a question about the MP-941 and is the answer not in the manual?
Questions and answers