Location; Electric Data Table; Light Bulbs And Glass Panels - Henny Penny DCW-2 Operator's Manual

2-3. LOCATION

2-4. ELECTRIC DATA TABLE

2-5. LIGHT BULBS AND
GLASS PANELS
Step 1
Step 2
Place the unit on a table, preferably with a cut-out opening below
the cabinet to allow easy service connections and serviceability.
When setting up the Henny Penny Heated Display Cabinet, be
sure to level the table.
Model
DCW-2
1. Cut the tape holding the doors shut and remove all boxes and
boxes and packing. One carton contains the glass panels and
the other contains the light bulbs.
2. Install the light bulbs and glass panels.
3. The unit is now ready to be cleaned per instructions in the
Operations section of this manual.
Replacing Light Bulbs
Light bulbs and glass may be hot. Severe burns could result.
1. Remove the glass panel by carefully pushing up on back of
panel and sliding away from you. The panel will fall into
your hand. See photo at left.
2. Remove the light bulb.
3. Replace the light bulb Henny Penny offered.
If this bulb is not available, a standard 60 watt bulb will work
until a long life bulb can be obtained.
4. Replace the glass panel.
5
Volts Phase Watts Amps
120/230 1 760 4.7