Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Service Manual
Advertisement
Table of Contents
Related Manuals for Henny Penny CW-114
Summary of Contents for Henny Penny CW-114
- Page 1 Henny Penny Display Counter Warmer Model CW-216/CW-114 OPERATOR’S MANUAL REGISTER WARRANTY ONLINE AT WWW.HENNYPENNY.COM...
- Page 3 During this time, any frypot that fails due to manufacturing or workmanship issues will be replaced at no charge for parts, labor, or freight. Henny Penny will either install a new frypot at no cost or provide a new or reconditioned replacement fryer at no cost.
-
Page 4: Table Of Contents
3-3. Start-Up ... 3-5 3-4. Operation with Product ... 3-6 3-5. Shut-Down and Clean-Up ... 3-7 Section 4. TROUBLESHOOTING ... 4-1 4-1. Troubleshooting Guide ... 4-1 GLOSSARY ... G-1 Distributor Lists - Domestic and International TABLE OF CONTENTS Model CW-216/CW-114 Page 1105... -
Page 5: Section 1. Introduction
The Henny Penny Display Counter Warmer has see-thru doors which allow viewing and also access to the hot foods. The CW-216 is a two tier cabinet and the CW-114 single base cabinet. As of August 16, 2005, the Waste Electrical and Electronic Equip- ment directive went into effect for the European Union. -
Page 6: Safety
1-5. SAFETY The only way to insure safe operation of the Henny Penny Display Counter Warmer is to fully understand the proper installation, operation, and maintenance procedures. The instructions in this manual have been prepared to aid you in learning the proper procedures. Where information is of particular importance or is safety related, the words NOTICE, CAUTION, or WARNING are used. -
Page 7: Section 2. Installation
Any shipping damages should be noted in presence of delivery agent and signed prior to his or her departure. To remove the Henny Penny Display Counter Warmer from the carton, you should: 1. Carefully cut banding straps. - Page 8 2-2. UNPACKING (Continued) Step 2 Step 3 Step 4 2. Open top flaps and remove packing. 3. Lift carton off skid. 4. Remove four bolts from under skid. Model CW-216/CW-114...
-
Page 9: Location
Place the unit on a table, preferably with a cut-out opening below the cabinet to allow easy service connections and serviceability. When setting up the Henny Penny Display Counter Warmer, be sure to level the table. The unit has built-in draining capabilities, but this becomes ineffective when set on an unlevel table. -
Page 10: Drain Connection
A separate disconnect switch with proper capacity fuses or breakers must be installed at a convenient location between the cabinet and the power source. The field supply wiring to the cabinet should be an insulated copper conductor rated for 600 volts and 90ºC. Model CW-216/CW-114 1004... -
Page 11: Electric Data Table
A straight-through bulkhead fitting is furnished with the unit for 1/4 inch copper tubing to protect the water line where it passes through the sheet metal. Reinstall the end panel. Model CW-216/CW-114 and L Amps 13.2 16.3 13.8... -
Page 12: Light Bulbs And Glass Panels
3. Replace the light bulb with a Westinghouse #60A19/35, 130 Volt bulb. If this bulb is not available, a standard 60 watt bulb will work until a long life bulb can be obtained. 4. Replace the glass panel. Model CW-216/CW-114... -
Page 13: Cabinet Dimensions
Model CW-216/CW-114 2-10. CABINET DIMENSIONS... -
Page 14: Section 3. Operation
Also, refer to the Installation Section to be sure the cabinet has been properly installed. The following figures identify and describe the function of all the operating controls and the major components of the cabinet. Model CW-216/CW-114... - Page 15 Model CW-216/CW-114 3-2. OPERATING CONTROLS (Continued) Figure 3-1 Figure 3-2 Figure 3-3 Figure 3-4 Figure 3-5 1107...
- Page 16 3-2. OPERATING CONTROLS (Continued) Figure 3-6 Figure 3-8 Figure 3-10 1107 Model CW-216/CW-114 Figure 3-7 Figure 3-9 Figure 3-11...
- Page 17 Indicates the water temperature An electro-mechanical device used to regulate the water temperature A two-position, three pole switch used to turn on and off the heat and water control systems Model CW-216/CW-114 1107...
-
Page 18: Start-Up
3” wide by 25” long; there are two heaters rated at 1020 watts each attached to the bottom of the water pan Before using, the Henny Penny Display Counter Warmer should be thoroughly cleaned as indicated in the Shut-down and Clean-up section of this manual. -
Page 19: Operation With Product
CW will NOT indicate if the product is holding at the proper temperature. Also, even though the unit has a thermometer on the controls for the water temperature, it may not accurate. Model CW-216/CW-114 1105... -
Page 20: Shut-Down And Clean-Up
9. Clean all surfaces with a soft cloth, soap, and water. 10. Clean around electrical controls with a damp cloth. 11. Install the drain standpipe and insert. 12. Turn off the lights. 13. Turn off the power switch. 14. Leave the doors open until ready to use again. Model CW-216/CW-114... -
Page 21: Section 4. Troubleshooting
Defective fuse • Faulty light bulbs • Bun pans are not over water • or 800-417-8405 or 937-456-8405. Model CW-216/CW-114 CORRECTION Keep doors closed when • possible Only hold product for • recommended times Turn to higher setting •... -
Page 22: Glossary
G L O S S A R Y HENNY PENNY HOLDING CABINETS a round device located inside the cabinet that measures the inside air temperature and sends that information to the control panel a metal assembly located in the water pan in the bottom of the unit that... - Page 23 NOT be used to clean a holding cabinet the area in the cabinet that holds water for creating humidity inside the cabinet Model CW-216/CW-114...
- Page 24 Henny Penny Corporation P.O.Box 60 Eaton,OH 45320 1-937-456-8400 1-937-456-8402 Fax Toll free in USA 1-800-417-8417 1-800-417-8434 Fax *FM05-020-F* www.hennypenny.com Henny Penny Corp., Eaton, Ohio 45320, Revised 11-27-07...