Table of Contents
Advertisement
2-8. WATER SUPPLY
CONNECTION
(Continued)
2-9. LIGHT BULBS AND
GLASS PANELS
2-6
This unit as manufactured requires the installation of an appro-
priate back-siphoning device (as per National Plumbing Code
ASA-A40:8-1955) to be connected to the water inlet line.
This device to be connected in accordance with basic plumbing
code of the Building Officials and Code Administrators Interna
tional, Inc. (BOCA), and the Food Service Sanitation Manual
of the Food and Drug Administration (FDA).
Install a water shut-off valve in a convenient location.
1. Cut the tape holding the doors shut and remove all boxes and
boxes and packing. One carton contains the glass panels and
the other contains the light bulbs.
2. Install the light bulbs and glass panels.
3. The unit is now ready to be cleaned per instructions in the
Operations Section of this manual.
Replacing Light Bulbs
Step 2
Light bulbs and glass may be hot. Severe burns could
result.
1. Remove the glass panel by carefully pushing up on back of
panel and sliding away from you. The panel will fall into
your hand. See photo at left.
2. Remove the light bulb.
3. Replace the light bulb with a Westinghouse #60A19/35,
130 Volt bulb.
If this bulb is not available, a standard 60 watt bulb will work
Step 1
until a long life bulb can be obtained.
4. Replace the glass panel.
Model CW-216/CW-114
203
Advertisement
Table of Contents
