Table of Contents
Advertisement
3-5. SHUT-DOWN AND
CLEAN-UP
E CLEANERS, OR CLEANERS
703
1. Turn the water thermostat to OFF.
2. Turn the radiant heat to OFF.
3. Turn the water control switch to OFF.
4. Remove the doors.
5. Remove all the pans.
6. Remove the drain standpipe.
7. Remove the insert from the water pan and clean with soap
and water at sink.
8. If you have a two tier unit (CW-216), remove wire pan support
from top section and clean with soap and water at sink.
Do not use steel wool, other abrasive cleaners, or
cleaners/sanitizers containing chlorine, bromine, iodine,
or ammonia chemicals, as these will deteriorate the
stainless steel, and glass material, and shorten the life of
the unit.
DO NOT USE ABRASIV
Do not use a water jet (pressure sprayer) to clean the unit,
or component failure could result.
9. Clean all surfaces with a soft cloth, soap, and water.
10. Clean around electrical controls with a damp cloth.
11. Install the drain standpipe and insert.
12. Turn off the lights.
13. Turn off the power switch.
14. Leave the doors open until ready to use again.
Model CW-216/CW-114
3-7
Advertisement
Table of Contents
