Changing The Switch Operation Mode - D-Link DES-3326 User Manual

1.
Layer 2 Only with IEEE 802.1Q VLAN support:
the switching process is based upon the source and
destination MAC addresses only.
are supported and the switch is considered as a
VLAN-tag aware device.
2.
IP Routing with IEEE 802.1Q VLAN support:
the switching process is based upon the IP source
and destination addresses, if present.
addresses are not present, the switching process is
based upon the MAC addresses (as in Layer 2
above).
switch is considered as a VLAN-tag aware device.
The switch must be rebooted when changing the operation mode
before the new operation mode can take effect.

Changing the Switch Operation Mode

To change the switch' s operating mode:
Highlight Switch Settings on the main menu and press enter.
Configuring the Switch Using the Console Interface
24-port NWay Ethernet Switch User's Guide
802.1Q VLANs are supported and the
802.1Q VLANs
If the IP
153