D-Link DES-3326 User Manual page 238

24-port NWay Ethernet Switch User's Guide
Note:
aggregation group as a single link, on the switch level.
On the port level, the STP will use the port parameters of
the base port in the calculation of port cost and in
determining the state of the link aggregation group. If
two redundant link aggregation groups are configured on
the switch, STP will block one entire group – in the same
way STP will block a single port that has a redundant
link.
To configure a link aggregation group:
Highlight Link Aggregation on the Main Menu and press
enter.
Toggle the Group ID:[1] field to one of the six possible link
aggregation groups configurable on the switch.
Master Module:<Base Unit> field to configure a group either
on the Base Unit (the 24 Fast Ethernet ports) or on the Slot-1
(optional) module (the 2 Gigabit Ethernet ports).
222
The Spanning Tree Protocol will treat a link
Figure 6-68. Link Aggregation Setup
Configuring the Switch Using the Console Interface
Toggle the