D-Link DES-3326 User Manual page 308

Port Member
Setup RIP
The Routing Information Protocol (RIP) is a distance-vector
protocol that uses the hop count as its criteria for making
routing decisions. RIP is an Interior Gateway Protocol (IGP),
which means that it performs routing within a single autonomous
system.
Parameter
Subnet Name
IP Address
Tx Mode
Rx Mode
292
24-port NWay Ethernet Switch User's Guide
Displays the ports that are members of
this IP interface and its corresponding
VLAN.
Figure 7-21. Setup RIP Screen
Description
Displays the name of the subnet on which
RIP is to be setup. This subnet must be
previously configured on the switch.
Displays the IP address corresponding to
the subnet name above.
Displays whether transmitted RIP packets
will be structured as V1 only, V1
Compatible, V2 Only, or Disabled. This
entry specifies which version of the RIP
protocol will be used to transmit RIP
packets. Disabled prevents the
transmission of RIP packets.
Displays whether received RIP packets
will be interpreted as RIP version V1 only,
Web-Based Network Management