24-port NWay Ethernet Switch User's Guide
Figure 6-45. Multicast Interface Configuration
Enter the name of the IP interface that is to be configured for
multicasting in the Interface Name:[
] field. This must be a
previously configured IP interface.
See Setting up IP
Interfaces, Chapter 6 of this manual for more information.
The IGMP: <
> field can be toggled between Enabled and
Disabled using the space bar. This will enable or disable IGMP
for the IP interface entered above.
The Protocol: <
> field can be toggled between Protocol
Independent
Multicasting
–
Dense
Mode
(PIMDM),
Distance Vector Multicasting Routing Protocol (DVMRP),
and INACT (inactive). INACT is not a multicast routing protocol.
It is used to make a given interface inactive for IP routing.
To configure the IGMP interface:
Highlight IGMP Interface Configuration from the Setup IP
Multicast menu and press enter.
Configuring the Switch Using the Console Interface
191