D-Link DES-3326 User Manual page 83

When the switch is in Layer 2 Only mode, 802.1Q VLANs are
supported.
Note: If no VLANs are configured on the switch and the
switch is in Layer 2 Only mode, then all packets will be
forwarded to any destination port. Packets with unknown
source addresses will be flooded to all ports. Broadcast
and multicast packets will also be flooded to all ports.
Note: Each IP interface on the switch corresponds to a
VLAN.
interface can be setup. The IP interface must have the
same name (and the same VID number)
corresponding VLAN.
Note: A VLAN that does not have a corresponding IP
interface defined for it, will function as a Layer 2 Only
VLAN – regardless of the Switch Operation mode.
Note:
before the IP interfaces can be setup on the switch. Some
consideration is required to arrive at an addressing
scheme that will suit the needs of a given network. Please
see the section titled IP Addressing and Subnetting in
Chapter 5 for more information.
The Layer 3 switch allows ranges of IP addresses (OSI layer 3) to
be assigned to VLANs (OSI layer 2).
configured prior to setting up the corresponding IP interface. An
IP addressing
implemented when the IP interfaces are set up on the switch.
An example is presented below:
VLAN Name
System (default)
Switch Management and Operating Concepts
24-port NWay Ethernet Switch User's Guide
The VLAN must be configured before the IP
An IP addressing scheme must be determined
scheme must
VID Switch Ports
1 5, 6, 7, 8, 21, 22, 23, 24
Each VLAN must be
then be established,
as its
and
67