Configure The Video Display; Change The Default Display Driver; Select A Dual-Screen Behavior - Intergraph Intense 3D Pro 1000 Installation Manual

10

Configure the Video Display

In Windows NT 3.51, open Video Config in the Control Panel to run
the Video Configuration program. Use Video Configuration to
configure the operation of the computer's video display when it is
controlled by the Intense 3D Pro graphics accelerator.
In Windows NT 4.0, open Display in the Control Panel to view the
Display Properties dialog. Use the Hardware Settings and Color
Calibration tabs to configure the operation of the computer's video
display when it is controlled by the Intense 3D Pro graphics
accelerator.
NOTE If you change any video attribute settings other than gamma
correction, you must restart the computer to make the changes
take effect.
For more detailed configuration information, refer to the
file delivered on the diskette containing the Intense 3D Pro driver.

Change the Default Display Driver

After you configure the video display as desired, change the default
display driver so that the Intense 3D Pro driver runs automatically
when you start the computer.
To change the default display driver:
1. In the Windows NT Control Panel, open System.
2. In the System dialog, under Operating System, select Windows
NT Workstation Version 3.51 or Windows NT Workstation
Version 4.0 from the displayed list, as appropriate.
3. Select OK.
NOTE Do not select the "VGA mode" version of the operating system.
The video display runs in VGA mode when the Intense 3D Pro
driver is not running.

Select a Dual-Screen Behavior

If your computer is configured for dual-screen display (with two
Intense 3D Pro Graphics Accelerators installed), the video display
driver treats the combined display area of the dual screens as a single
canvas that covers both screens. In this Full Canvas style, windows
centered on the canvas are split between the two screens. This
includes most system dialog boxes.
.
README TXT