Surround And Trim Set - Cast; Surround & Trim Set, Basic - Quadra-Fire MTVERNINSAE-MBK Installation Manual

MT VERNON AE INSERT
E. Surround and Trim Set - Cast
Included in Surround Kit: (2) side panels, left and right;
(1) panel top; (1) fastener package.
Included in Cast Trim Kit: (2) cast trim legs, left and right;
(1) cast trim header; (2) cast trim footers, left and right; (1)
fastener package.
Tools Needed: Powered Phillips head screw driver
1. Remove contents from box being careful not to scratch or
damage the cast trim pieces.
2. Lay the surround set face down on protective covering to
prevent scratching the painted surface.
3. Secure the surround legs to top panel with the screws
provided.
4. Now bend the tabs down toward the backside of the panel
set, 5 on top and 2 on each leg. Leave the panel set face
down. Figure 20.1
5. Place the corresponding cast trim pieces ( 2 cast trim legs
and 1 cast trim header) underneath the panel set, also face
down.
6. Place washer provided over tab and secure the trim and
panel together with screw. Continue for all tabs.
7. Secure cast footers with screws.
8. Remove both left and right cast sides from insert. Figure
20.5
9. Carefully slide surround and trim over the top of the
insert into place matching the mounting holes on the
panel with the mounting holes on the insert. Secure with
screws provided. Figure 20.5.
2. Bend tabs down
1. Screw panels
together
3. Install Cast Trim Header
Figure 20.1
Figure 20.2- Completed View
20
F. Surround & Trim Set, Basic
Included in Surround & Trim Kit: (2) corner brackets and set
screws; (1) trim set, 3 piece; (2) side panels; (1) top panel;
(4) screws.
Tools Needed: Powered Phillips head screw driver
1. Secure the top panel to the surround sides with the
screws provided. Figure 20.3
2. Assemble the trim with the (2) corner brackets provided.
Figure 20.4
3. Remove the 2 cast sides and slide the assembled trim
over the assembled surround set.
4. Carefully s
into place matching the mounting holes on the panel with
the mounting holes on the insert. Secure with screws
provided. Figure 20.5
1. Screw panels
together
2. Bend tabs
down
Figure 20.5
7036-188J
lide surround and trim over the top of the insert
Back of Top Surround
Screws
Back of Side Surround
Figure 20.3
Figure 20.4
Shown with Trim Installed on Surround Set
Figure 20.5
October 3, 2017