Install Cooktop - KitchenAid KFGS306VSS Technical Education

Flush-mount gas cooktop
Hide thumbs Also See for KFGS306VSS:
Table of Contents

Advertisement

INSTALL COOKTOP

WARNING
Excessive Weight Hazard
Use two or more people to move and
install cooktop.
Failure to do so can result in back or
other injury.
Style 1: Cooktop over undercounter built-
in oven
IMPORTANT: Clamping brackets should not
be used.
1.
Using 2 or more people, place cooktop
right side up into the cutout.
NOTE: Make sure that the front edge of
the cooktop is parallel to the front edge of
the countertop. If repositioning is needed,
lift entire cooktop up from cutout to avoid
scratching the countertop.
Style 2: Cooktop over cabinets
1.
Determine whether your cabinet construc-
tion provides clearance for installing clamp-
ing brackets at cooktop base ends. This
is the recommended location. Clamping
brackets can be installed on the front and
back of cooktop base bottom, if neces-
sary.
A
B
A. Attachment screw holes for optional front and back
location.
B. Clamping bracket (end locations recommended)
C. cooktop base bottom
D. Attachment screw
E. Attachment screw location (recommended)
INSTALLATION REQUIREMENTS
2.
The clamping brackets can be installed
before or after the cooktop is placed into
the cutout. Complete the following steps
for the option you choose.
Installing Brackets Before Placing Cook-
top in Cutout
1.
Using 2 or more people, place the cooktop
upside down on a covered surface.
2.
Remove the attachment screws for the
selected bracket locations from the bottom
of the cooktop base.
3.
Select bracket mounting holes that will al-
low the bracket to extend far enough out
from the cooktop for the installation of
2 1/2" (6.4 cm) clamping screws. See "At-
tach Cooktop to Countertop" for illustration
of clamping screw installation.
A. Edge of cooktop base bottom
B. Clamping bracket
4. Attach brackets to cooktop base bottom
C
with bracket attachment screws using the
D
bracket mounting holes selected in Step
2.
5.
Rotate brackets so they do not extend
beyond edge of cooktop base.
E
6.
Tighten screws just enough to hold brackets
in place when cooktop is put in cutout.
7. Using 2 or more people, turn the cooktop
right side up and place in cutout.
2-5
A
B

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kfgu706vssKfgs366vssKfgu766vss

Table of Contents