Install Cooktop - KitchenAid KICU509XBL Installation Instructions Manual

Excessive Weight Hazard
Use two or more people to move and install cooktop.
Failure to do so can result in back or other injury.
1. Using 2 or more people, place the cooktop upside down
on a covered surface using the foam end posts from the
packaging.
2. Remove the foam roll from the package containing literature.
Apply foam adhesive-side down around the bottom of the
cooktop glass.
NOTE: The foam helps avoid damage to the underside of the
cooktop glass from debris and helps the cooktop sit flat on
uneven counters.
A. Cooktop base
B. Foam
C. Assembly glass
3. Lower the cooktop into the cutout with the front end of the
cooktop angled down.
4. Make sure that the clips on each side of the cooktop line up
with the brackets in the cutout.
A
6
05-Sep-2019 13:08:05 EDT | RELEASED
WARNING
A
B
C
A. Clip
In some European factories the letter "W" of the part code mentioned herein will be automatically

Install Cooktop

5. Push down on cooktop to snap the cooktop clips onto the
brackets installed in the cutout.
6. On the underside of the cooktop, loosen the 4 screws on the
slider.
A
7. Push the cooktop slider toward the side of the cabinet until
the slider and cabinet touch.
8. Tighten the screws on the slider.
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
A
B
A. Induction cooktop
B. Cooktop cutout
B C
A. Side of cabinet
B. Cooktop slider
C. Screw