KitchenAid KFGS306VSS Technical Education page 25

On all models, remove the metal cooktop and
the sheet of insulation from the cooktop base.
A
B
C
A. Metal cooktop
B. Sheet of insulation
C. Cooktop base
9. To Convert Right or Left Burners:
• Insert 7.0 mm nut driver down onto the gas
orifice spud and remove by turning it coun-
terclockwise and lifting out.
• Set gas orifice spud aside.
• Replace with correct LP gas orifice spud. See
the LP Gas Orifice Spud Charts.
10. To Convert Center Burners:
• Use 10.0 mm wrench to loosen and remove
the orifice.
• Replace with correct LP gas orifice spud. See
the LP Gas Orifice Spud Charts.
• Use Phillips screwdriver to loosen the venturi
screw. Slide the brass venturi into the injec-
tor, stop at the second groove (C). Securely
tighten the venturi screw.
A. Ori ce
B. Venturi
C. Second Groove
(16.0 mm LP gas
setting)
• Use 15.0 mm wrench to loosen the nut secur-
ing the tube to the orifice pack. Remove the
tube from the orifice pack.
B
A
A. Tube
B. Attachment nut (15.0 mm)
• Use 17.0 mm wrench to loosen and remove
the orifice pack.
• Replace with correct LP gas orifice spud.
See the LP Gas Orifice Spud Charts.
• Replace adapter nut and secure with 17.0
mm wrench. Reattach tube and secure at-
tachment nut with 15.0 mm wrench.
11. Place Natural gas orifice spuds in plastic
parts bag for future use and keep with
literature package.
12. Replace sheet of insulation.
13. On KFGU models only, reattach wire har-
ness to the control panel on the cooktop
glass.
14. Replace the metal cooktop and tighten all
the screws to secure cooktop to base.
15. Replace burner bases and tighten all the
orifice holder screws. Replace burner caps.
If necessary, replace burner ring.
2-15
A B
C D
D. First groove (12.0 mm
natural gas setting)
E. Venturi screw
C D
C. Adapter nut (17.0 mm)
D. Ori ce spud
E