Placing The Ember Material - Heat & Glo SL-350TRS-CE-D Installer's Manual

6
LOG #6 (SRV540-704):
If sooting occurs, the logs might need to be repositioned slightly to avoid excessive flame impingement.

Placing the Ember Material

Ember material is shipped with this gas fireplace. The bag
labeled Glowing Ember (050-721) is standard glowing ember
material. To place the ember material:
• Remove latches and tension springs around the glass door.
• Remove the glass door from the unit (Figure 44).
• Place small pieces of ember material on burner top around
burner ports (Figure 33). Do NOT press embers into
burner ports. Cover the top of the burner with a single
layer of ember material. Do NOT place embers behind
the rear port row as noted in Figure 45.
• Save the remaining ember materials for use during fireplace
servicing.
• Replace the glass door and a front trim door on the unit
(see Replacement Parts Section of the manual.)
• Replace the latches and tension springs.
DO NOT PLACE EMBERS BEHIND THE REAR BURNER PORTS.
Figure 45. Placement of the Ember Material
38
Place log #6 against the second and third grate bars.
Heat & Glo • SL-350TRS-CE-D • 2033-900 Rev. N • 10/07
6
LATCHES
(BOTH TOP
AND BOTTOM)
GLASS
ASSEMBLY
Figure 44. Glass Assembly