Multitech MultiModem rCell MTCBA-H-EN2 User Manual page 25

I P Setup > SNTP Configuration
8 1 B
General Configuration
SNTP Client: Enable or disable the SNTP Client to contact the configured server on the UDP port 123 and set the local
time. The default is Disable.
Server: Enter the SNTP server name or IP address to which the SNTP Client must contact in order to update the
time. No default.
Polling Time: Enter the polling time at which the SNTP client requests the server to update the time. Default is 300
minutes. Time must be entered in minutes.
Time Zone Configuration
Time Zone: Enter your time zone. Default = UTC (Universal Coordination).
See the following Web site for Time Zone information:
Time Zone Offset: Enter +/- hh:mm. Default = +00:00. Offset is the amount of time varying from the standard time of a
Time Zone.
Daylight Configuration
Daylight Saving: Enables/disables Daylight Saving mode. The default is Enable.
Daylight Saving Offset:
minutes.
Daylight Saving Start Time
Start Ordinal: Set the start ordinal to use during Daylight Saving mode. Options are first/second/third/fourth/last. Default is
first. Daylight Saving time usually starts at the same time on the same day of the week in the same month
every year. Each day of the week occurs four or five times a month. Therefore, you will be selecting the week
in which daylight saving time starts: the first, second, third, fourth or the last of the month.
Start Month: Set the start month to use during Daylight Saving mode. Default is April.
Start Day: Set the start weekday to use during Daylight Saving mode. Default is Sunday.
Start Time: Set the start time to use during Daylight Saving mode. Default is 02:00 (hh:mm).
Multi-Tech Systems, Inc. MultiModem rCell User Guide
http://wwp.greenwichmeantime.com/info/current-time.htm
Set the offset to use during Daylight Saving mode. Default is +60 minutes. Enter the time in + / -
Chapter 3 – Using the Web Management Software
25