Configuring The Destination For Appletalk Networks - Canon imagePROGRAF iPF655 User Manual

Network Setting > Mac OS X Settings

Configuring the Destination for AppleTalk Networks

To print over an AppleTalk network, activate the AppleTalk protocol and configure the destination as follows.
Activating AppleTalk on the printer
Important
• By factory default, the AppleTalk protocol is disabled on the printer.
1.
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to select the Settings/Adj. tab (
2.
Press the OK button.
The Set./Adj. Menu is displayed.
3.
Press ▲ or ▼ to select Interface Setup, and then press the OK button.
10
4.
Press ▲ or ▼ to select AppleTalk, and then press the OK button.
5.
Press ▲ or ▼ to select On, and then press the OK button.
6.
Press the Menu button.
If any of the settings is changed, a confirmation message is displayed. In this case, press the OK button.
792
Important
• Be sure to complete step 6. This will activate the values you have entered.
Configuring the Destination for AppleTalk Networks
>
Note
• If the Tab Selection screen is not displayed, press the Menu button.
).
iPF655