Dish Network ViP222 User Manual page 108

Chapter 11
Connecting an Over-the-Air Antenna
off the bottom of the screen, which you can access with the remote's UP or DOWN ARROW
buttons if you wish to edit their names or remove them from the list of scanned-in channels.
6
If you want to name the over-the-air channels, continue on. If you do not want to name your over-
the-air channels, select Done. You will then exit the menus and resume watching TV.
7
Select a channel and then select Edit Name to modify the way the channel name displays on your
screen.
8
Use the virtual keyboard on the screen to select the letters of your channel name.
9
When you are finished making changes, select Done.
Peaking Your Over-the-Air Antenna
1
Make sure that you have your over-the-air antenna properly connected to the receiver's 8VSB TV/
A C
NTENNA ABLE
1
Press the MENU button, select System Setup (6), and then Local Channels (9) to open the Local
Channels menu screen.
2
Highlight the Channel field and use the UP and DOWN ARROWS to select a digital over-the-air
channel. Make sure you see a green signal strength bar and a Locked indication on the meter.
3
Adjust the orientation of your OTA antenna to maximize the signal strength. If you cannot get a
Locked indication, you may need to upgrade, reposition, or reinstall your OTA antenna.
Using Local Satellite Channels
If you want to receive your loca lTV channels from DISH and want to see the them listed in the
receiver's Program Guide by their OTA broadcast number, enable the Sat Locals feature.
Otherwise, the local satellite-delivered channels will display in the four-digit channel range.
100
I jack.
N