Remote Control Batteries; Low Battery Warning - Dish Network ViP222 User Manual

Remote Control Batteries

The remote control comes with AAA batteries. When you replace old
batteries, you should replace all four batteries. Use batteries of the same
type, for example, alkaline or carbon zinc. Don't mix batteries of different
types. Alkaline batteries last longer.
1
Press down on the top of the battery cover and slide the cover off.
2
Take out all of the old batteries.
3
Put the new batteries in. Make sure you match the plus ("+") ends with the
plus markings on the battery case.
4
Slide the battery cover back into place.

Low Battery Warning

When you see a low-battery warning message on your screen below the Program Banner,
the batteries in your remote control are weak and need to be replaced.
Attach the Remote Antenna
Attach the remote-control antenna to the receiver's back-panel R
jack so you can use your UHF Pro Remote Control 2. Without the remote-control antenna,
you cannot use this remote to control the receiver. See Adjusting the Remote Antenna on
page 60 for more detailed information about improving the performance of your UHF Pro
remote control.
Satellite Receiver
Remote Controls
A input
EMOTE NTENNA
15