Using The Recover Button - Dish Network ViP222 User Manual

Programming the Recover Button for Remote Control 2
When your Remote Control 2 is shipped from the factory, RECOVER is set up to restore
satellite TV viewing by tuning your TV (or VCR, if programmed) to channel 3, 4, and other
inputs. However, to use RECOVER with your remote TV(s) or VCR, you need to program
RECOVER with the specific channel (for example, channel 60) that you use to watch TV2-
output programming. The following instructions describe how to program the RECOVER
button to tune your remote TV(s), or VCR if applicable, back to the specified channel.

Using the Recover Button

The following setup is required to use RECOVER:
• The remote control must be set up to control the TV and, if one is installed, the VCR.
• If a VCR is installed for TV2, make sure that it is connected as shown on page 96.
• On a remote TV, the RECOVER button must be programmed to tune your remote TV
to the specific channel to receive TV2-output programming (for example, channel 60),
using the instructions on page 71.
Note 1: Press any remote-control button other than RECOVER to end this procedure.
Note 2: If RECOVER is not programmed to a specific channel, then RECOVER will first try
to tune your TV to channel 3, then channel 4, and then other video inputs with each press
of the RECOVER button. You may need to press RECOVER up to 30 times to recover
your satellite TV video. If RECOVER is programmed to a specific channel (see page 71),
pressing RECOVER will tune the TV to the specific channel (for example, channel 060).
Remote Controls
The Recover Button
71