Onnecting A Vcr To The R Emote Tv - Dish Network ViP222 User Manual

Chapter 11
Connecting a VCR to the Remote TV
C
ONNECTING A
The diagram below provides example of how to connect VCRs to your satellite TV system.
For this installation, always leave your VCR powered on so that the TV can receive
satellite programming. If you turn off your VCR, your TV will not be tuned to the
correct channel to receive satellite programming.
Note: Connecting your TV directly to the satellite receiver provides the best audio and video
quality.
1
Connect the tuner input of the remote VCR to an existing wall cable outlet using a coaxial cable.
2
Connect a coaxial cable from the output on the VCR to the remote TV's tuner port.
3
Plug in and turn on the remote VCR and TV.
4
Tune the remote VCR to the remote TV channel that you use to watch satellite TV programming
(for example, channel 60) as set on page 90.
5
Write the channel number you tuned your VCR to in the previous step on one of the TV2 channel
stickers. Place the sticker on or near the VCR. This sticker will remind you which VCR channel to
use to watch satellite programming. The stickers are located in the inside front cover of this guide.
6
Set the VCR output to channel 3 or 4.
7
Tune the remote TV to the same channel to which you set your VCR in step 6.
8
Write the channel number you tuned your TV to in the previous step on one of the TV2 channel
stickers. Place the sticker on or near the TV. This sticker will remind you which channel to use to
watch satellite programming. The stickers are located in the inside front cover of this guide.
96
VCR
TO THE
TV
OUT
Coaxial Cable
VCR
IN
Coaxial Cable
IN
R TV
EMOTE
IN
Coaxial Cable
IN