The Recover Button - Dish Network ViP222 User Manual

Chapter 9

The Recover Button

1
Turn on the other receiver and press the SYSTEM INFO button to display the System Info
screen.
Write the address:
2
Press and hold the AUX mode button on the remote until all the other device mode but-
tons light up, and then release the button. The AUX mode button flashes.
3
Press the 3 button on the remote's NUMBER PAD.
4
Use the NUMBER PAD to enter the address you wrote down in step 1.
5
Press the remote's POUND (#) button. The AUX mode button flashes three times.
6
Press the remote's RECORD button and ensure that the address you programmed for the
remote matches the address displayed on the receiver's System Information screen.
T R
HE ECOVER
Use RECOVER if you suddenly have a snowy, all-blue, or black screen on your TV and
cannot get the picture back from your satellite receiver. When you press RECOVER as
described below, the remote control sends commands to your TV to change channels or
video inputs to get back to watching satellite programming. This procedure works only if
you have accidentally changed the TV channel or video input. It does not recover a lost
satellite signal (See Troubleshooting on page 106 for information on solving problems).
Note 1: The remote must be programmed to control the TV (and VCR, if applicable) for
RECOVER to work as described.
Note 2: RECOVER will first try to tune your TV to channel 3, then channel 4, and then
other video inputs with each press of the RECOVER button. You may need to press
RECOVER up to 30 times to recover satellite TV video. If RECOVER is programmed to a
specific channel (see page 71), the pressing the RECOVER button will tune the TV only to
the specific channel (for example, to channel 60 if you programmed 060 as the channel).
70
B
UTTON