IBM 10/100 EtherJet User Manual page 32

Advanced information
Command Description
\Q Local flow control selection:
\Q0: Disable flow control. Same as &K0.
\Q1: XON/XOFF software control. Same as &K4.
\Q2: CTS-only flow control. This is not supported and the response is ERROR.
\Q3: RTS/CTS to DTE (default). Same as &K3.
\R Ring indicator off after answer:
\R0: Ring indicator signal if off after the telephone call is answered.
\T Inactivity timer:
\T0: Inactivity timer disabled (default).
\Tn: Inactivity timer, n minutes (n=1-255).
\V Protocol result code:
\V0: Disable protocol result code appended to DCE speed.
\V1: Enable protocol result code appended to DCE speed (default).
\V2: Same as \V1.
\X XON/XOFF pass through:
\X0: Modem process XON/XOFF flow control characters locally (default).
\X1: Modem passes XON/XOFF flow control characters.
%B View numbers in blacklist:
Displays the numbers for which the last call attempted in the passed two hours failed.
%C Data compression control:
%C0: V.42bis/MNP5 disabled. No data compression.
%C1: V.42bis/MNP5 enabled. Data compression enabled (default).
%E Automatic rate change:
%E0: Disable fallback or fall forward.
%E1: Enable fallback, disable fall forward.
%E2: Enable fallback or fall forward (default).
-C Data calling tone:
-C0:
-C1:
-V90 Enable/disable V.90 setting:
-V90=0: Disables V.90.
-V90=1: Enables V.90 auto rate (default).
-V90=n: Controls the downstream rate (2-23).
-V90=?: Shows the range of n.
-V90?: Shows the current value.
Modem S Registers
Register Function
S0 Auto Answer Ring Number
S1 Ring Counter
S2 AT Escape Character (user-defined)
22
Disabled (default).
Enabled
Register/Units
0-255 rings
0-255 rings
0-127 ASCII